Holybro PM02D 2-12S High Voltage Power Module for Pixhawk 5X / 6X FC Drone-image
Holybro PM02D 2-12S High Voltage Power Module for Pixhawk 5X / 6X FC Drone-image
Holybro PM02D 2-12S High Voltage Power Module for Pixhawk 5X / 6X FC Drone-image
Holybro PM02D 2-12S High Voltage Power Module for Pixhawk 5X / 6X FC Drone-image
Holybro PM02D 2-12S High Voltage Power Module for Pixhawk 5X / 6X FC Drone-image

Holybro PM02D 2-12S High Voltage Power Module for Pixhawk 5X / 6X FC Drone

$ 22.09

Country of Origin: China Type: Power Module Materials sourced from: China Compatible Fuel Type: Electric gtin13: Does not apply MPN: Does not apply Model: PM02D-HV UPC: Does not apply Brand: HolyBro Age Level: 17 Years & Up

Description

Note PM02D HV version is supported by PX4. For Ardupilot, it is supported in Ardupilot latest/master FW, or version 4.4 and later. This PM uses I2C digital signal data output and is not compatible with flight controller that uses analog PM such as the Pixhawk 6C & Mini, Pixhawk4 & Mini, pix32 v5, or Durandal flight controllers. PM02D provides regulated power supply for your Pixhawk® 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6pin cable. The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 6S (LV) or 12S (HV). The Power Module comes completely assembled with XT60 connectors, wrapped in shrink tubing for physical damage protection. It is not designed to power servos, please use your aircraft's ESC/BEC for that. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact. Specification Input voltage HV: 2S-12S PCB Cont. Current Rating: 60A PCB Burst Current Rating: 100A (<60 Sec) Max current sensing: HV: 327A Voltage and current monitor with I2C compatible interface Outputs 5.2V and 3A max Weight: 20g Current Rating The PM02D comes with XT60 plugs with 14 AWG silicone wires rated for 30A continuous current and 60A burst current (<1 minute). If a higher current is needed, the plug type and wire size should be changed accordingly. You can refer to this chart as reference. PX4 Parameter Setup If you are using the PM02D HV version, you must set SENS_EN_INA228 to enable. Packing List 1 x PM02D Power Module 1 x 6Pin 2.00mm Pitch Cable

  1. Hop up is awesome. Exactly as described. This is a great seller. A+++++ Transaction. Will do business again....highly, highly recommend....shipping was VERY fast to Texas despite being shipped from China...

    Shane Crompton

  2. I have not opened the package yet or used this camera but the seller was fine. Typical of most purchases from Chinese sellers. The item was packed well, no tariff issues, and appears to be in cold shape.

    user23463337

  3. Shipping was slow. Took over 2 weeks. But item as described. Would be better with upgrade shipping options

    Yixi Shan005

Related products