Digital Thermostat Controller Board Kit Fit for Z Grills Pellet BBQ Digital T...
$ 31.13
Description
Installation steps: 1) Disconnect the power supply of the grill; 2) Remove the screws on the bottom plate of the grill with a screwdriver and remove the bottom plate; 3.) Locate the harness, disconnect all connections, and remove the old digital thermostat controller board with the help of a tool; 4) Connect the probe wire to the position of the blue box on the new controller board; 5) Reinsert the new plug into the connector in the original order, then reattach the controller to the grill. Professional personnel are recommended to perform the installation. Note: 1) Please know more about this product before purchase, whether it your oven model. 2) After the error is displayed, please check the meaning of the garbled code listed in the product description. If it is not included, please check the oven motor, fan, ignition rod, etc. 3) It is recommended to find professional installation for specific installation. 4) The interface should be inserted tightly during installation. If the interface is not inserted tightly at will, it will be loose later, resulting in short circuit or other faults. 5) When the temperature drops to about 180, add the auger to the pot, it will take about 5 minutes to start producing more smoke. Specifications: Input: AC 120V 60Hz (PIN1-4) Output: AC 7.5V 200mA (PIN5~6) models: Digital Thermostat controller boards fit for parts for Z grill pellets, wood pellet grills and BBQ digital Professional thermostat control panels. Circuit board material: Circuit board of the digital thermostat controller board is made of FR-4 (glass fiber epoxy material) material, light weight and heat stability; The control panel with LCD display is clear and obvious, which can clearly and accurately display the temperature, so that you can enjoy the fun of barbecue easily and happily. Smoke Mode: Digital thermostat Wood Pellet Z grill controller board has smoke mode and temperature mode from 225 ° F to 450 ° F (maximum). Code problem: ERR indicates that the furnace temperature probe may be disconnected. Please check whether the connection is correct; ERL indicates ignition failure, it is recommended to check whether there is a problem with the fire rod; ERH indicates that the temperature has exceeded the recommended level, causing the controller to automatically shut down and stop feeding. You can open the cover to cool off and restart the machine later. Wiring instructions: Purple wire is used to connect the ignition rod. The black cable is used to connect the power supply. The red wire is used to connect the motor. The orange cable is used to connect the fan motor.
